User Manual - Mistral 24 V1.2 05/2015 9/52
RECORD
+
• 1 - Press and hold down the record button.
• 2 - While holding down the Record button, tap the Flash buttons 1, 6, 6 and 8 in sequence.
• 3 - Release the Record button, the Record LED lights up, now you can begin programming
your chase patterns.
NOTE:
The first time you turn on your unit, the default setting of the Record Code is Flash buttons 1,
6, 6 and 8.
You may change the Record Code to protect your programs.
Security for Your Programs
To protect your programs from any editing by others, you may change the Record Code.
• 1 - Enter current Record Code(Flash buttons 1, 6, 6 and 8).
• 2 - Press and hold down the Record and Edit buttons at a time.
• 3 - While holding the Record and Edit buttons, tap the desired Flash button to enter a new Record Code
The Record Code consists of 4 Flash buttons(the same button or different buttons), be sure your
new Record Code consists of 4 Flash buttons.
• 4 - Enter your new Record Code a second time, all channel LEDs and scene LEDs will flash
three times, now the Record Code is changed.
• 5 - Exit Record mode. Tap the Rec Exit button while pressing and holding down the Record
button, release the two buttons at a time, the Record mode is disengaged.
IMPORTANT!!!
Always remember to exit Record mode when you won’t continue your programming, otherwise
you may lose control of your unit.
To Next Page
Loading...
Need help?
General