3.5
4 x M2.5x8 Hex Cap Screw
2 x M2.5x6 Hex Cap Screw
2 x STD Servo Tab
Tail Servo Assembly
Tail Push Rod Assembly
Arm position with
centered Rudder stick.
Nose Left Nose Right
With Rudder Stick centered
and the Tail Servo Arm in the
center position, adjust the
Tail Push Rod length until the
Tail Bell Crank and Tail Case
Plate are parallel as shown.
The Oxy 4 Tail System has
approximately 3.5 of counter
torque with the Tail Bell Crank
set per instructions.
loctite 243
Leveler
( Accessories Bag )
Chapter 14: Servo & Servo Rod installation
page 40
To Next Page
Loading...
