7
BATTERY AND CHARGER SAFETY WARNINGS
!
!
!
!
• The longest life and best performance can be obtained if the battery pack is
charged when the air temperature is between 18 - 24ºC. Do not charge the
battery pack in an air temperature below 10ºC or above 40ºC. This is
important and will prevent damage to the battery pack.
• Do not incinerate the battery pack even if it is seriously damaged or is
completely worn out. The battery can explode in a fire.
• Never attempt to open the battery pack for any reason. If the plastic housing
of the battery pack breaks or cracks, immediately discontinue use and do
not recharge.
• During charging, the battery must be placed in a well ventilated area.
• Hold power tool by insulated gripping surfaces, when performing an
operation where the cutting accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may make exposed metal
parts of the power tool "live" and could give the operator an electric shock.
• Do not use the drill in wet or damp conditions.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
• Recommendations for the use of a residual current device with a rated
residual current of 30mA or less.
• It is recommended that the extension lead is a maximum of 25m in length. Do
Not use multiple extension leads.
• Wear a hard hat (safety helmet), safety glasses and/or face shield. It is also highly
recommended that you wear a dust mask, ear protection and padded gloves.
• Check the blade carefully for cracks or damage prior to operation. Replace
cracked or damaged blades immediately.
• Hold the tool firmly during operation.
• Always hold the front shoe firmly to the work piece.
• Ensure no one is below you when using the tool in elevated conditions.
• Do not point the tool at anyone in the immediate vicinity.
WARNING! When making a "blind" cut (you can't see behind what is
being cut), be sure that hidden electrical wiring or water pipes are not
in the path of the cut. If wires are present, they must be disconnected
at their power source by a qualified person or avoided to prevent the
possibility of lethal shock or fire.
• Water pipes in "blind" ar
eas must be drained and capped befor
e cutting.
• If the blade hits against objects during operation, damage to the tool or
dangerous blade br
eakage may occur
.
CUT SAW SAFETY WARNINGS!
!
!
To Next Page
Loading...
