Ozito OSP-780 - Know Your Product; Setup & Preparation

Installing The Universal Adaptor
The universal adaptor is designed to fit various sizes of pipes and
fittings.
To fit a 25mm (1’’) rigid pipe or flexible tubing (temporary or
permanent application only)
No cutting of the universal adaptor
is required. It is ready to be fitted
with a 25mm (1’’) rigid pipe or
flexible tubing (not included).
To fit a 25mm (1’’) Tap Adaptor
(temporary application only)
1. Cut the universal adaptor using a
hack saw. Ensure all flashing is
removed.
2. It is now ready to be fitted with a
25mm (1’’) screw on tap adaptor
(not included).
To fit a 32mm (1¼’’) rigid pipe or flexible tubing (temporary
application only)
Cut the universal adaptor using
a hack saw. It is now ready to be
fitted with a 32mm (1¼’’) rigid pipe
or flexible tubing (not included).
1. Float Switch
2. Pump Housing
3. Float Switch Adjuster
4. Float Switch Cable
5. Handle
6. Outlet
7. Suction Base
SUBMERSIBLE PUMP
ACCESSORIES
KNOW YOUR PRODUCT
1. ASSEMBLY
SETUP & PREPARATION
8. L-Shape Connector 9. Universal Adaptor
4
5
6
7
1
2
3
9
8
WARNING! ENSURE THE TOOL IS TURNED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING OPERATIONS.
NOTE! TO USE THE PUMP IN PERMANENT
INSTALLATIONS WITH RIGID PIPES, INSTALL A
NON-RETURN VALVE TO AVOID THE FLUID BEING RE-
CIRCULATED ONCE THE PUMP HAS STOPPED.
ONLINE MANUAL
Scan this QR Code with your mobile
device to take you to the online manual.