Manual Operation
When the float switch is held in the
vertical position the pump will run
continuously.
1. Ensure the distance from the lowest to the highest point that
you wish to distribute the water does not exceed 8 metres.
2. Ensure that the container is large enough to allow the float
switch to move freely and function effectively, A minimum of
area of 50x50x50cm is required.
3. Ensure the pump is placed on a flat and level surface, there are
no obstructions to the suction base and out of mud or sediment.
4. USAGE
MIN. 50x50x50CM
MAX. IMMERSION
7 METRES
MAX. HEAD
8 METRES
WARNING! NEVER CARRY, LIFT OR PULL UP THE PUMP
BY THE POWER CORD. THIS WILL DAMAGE THE UNIT.
WARNING! TO PREVENT THE PUMP RUNNING DRY,
THIS OPERATING MODE IS ONLY ALLOWED UNDER
SUPERVISION. THE PUMP MUST BE SWITCHED OFF
AS SOON AS NO MORE WATER IS EMITTED FROM THE
DISCHARGE LINE.
WARNING! THIS PRODUCT IS INTENDED FOR
PUMPING WATER IN A HOME DOMESTIC APPLICATION.
DO NOT USE IT FOR CORROSIVE, ABRASIVE,
EXPLOSIVE OR DANGEROUS LIQUIDS.
To Next Page
Loading...
