SINC 250314-24 3
3
15”
22 1/4”
Minimum Clearances to Combustibles
(Measured From Insert Body)
Adjacent Sidewall ..........................8 in. (203 mm.)
Mantel ..........................................15 in. (381 mm.)
Top Facing ................................... 15 in. (381 mm.)
Side Facing (1.5 in. extension) ...... 8 in. (203 mm.)
Safety
Please read this entire manual before installation
and use of this wood burning insert. Failure to follow
these instructions could result in property damage,
bodily injury or even death.
We strongly recommend that smoke detectors be installed.
If smoke detectors have been previously installed, you may
notice that they are operating more frequently. This may be
due to curing of stove paint or fumes caused by accidentally
leaving the re door open. Do not disconnect the detectors.
If necessary, relocate them to reduce their sensitivity.
SAFETY NOTICE: If this stove is not properly installed, a
house re may result. For your safety, follow the instal-
lation directions. Consult local building or re officials
about restrictions and installation inspection require-
ments in your area.
Clearances
Masonry or Factory Built Fireplace
The minimum required clearances to surrounding combus-
tible materials when installed into a masonry or factory built
replace are listed below and in gure #1.
Fig. # 1
Mantel or Top Facing
Side Facing
Fireplace
Hearth
Adjacent Wall
NATIONAL
FIREPLACE
INSTITUTE
CERTIFIED
www.nficertified.org
We recommend that our products be
installed and serviced by professionals
who are certified in the U.S. by the
National Fireplace Institute (NFI)
or in Canada by Wood
Energy Technical
Training (WETT)
Wood Energy
Technical Training
www.wettinc.ca
CAUTION: Unit hot while in operation. Parts of the appli-
ance, especially the external surfaces, will be hot to touch
when in operation. Keep children, clothing and furniture
away. Contact may cause skin burns.
To Next Page
Loading...
