To Next PageTo Next Page
Need help?Do you have a question about the Pacific C Series and is the answer not in the manual?
General| Category | Indoor Fireplace |
|---|---|
| Fuel Type | Natural Gas or Propane |
| Venting | Direct Vent |
| Ignition Type | Electronic |
| Dimensions | Varies by model |
| Warranty | Limited Lifetime Warranty |
Minimum clearances to surrounding combustible materials for installation into masonry or factory built fireplaces.
Hearth dimensions and requirements for fireplace installations, measured without the insert.
Non-combustible material requirements for floor protection in front of the fireplace insert.
Minimum required fireplace opening and hearth dimensions for insert installation.
Steps and considerations for installing the insert into a masonry fireplace.
Procedure for installing a full flue liner, required in Canada.
Procedure for direct flue connection, specified for USA installations.
Requirements for installing the insert into a factory built fireplace.
Explanation of automatic and manual operation for the variable speed circulating air blower.
Details on the blower's electrical rating and safety precautions for connection.
Guidelines for selecting and testing wood for optimal burning performance.
Step-by-step instructions for safely starting a fire in the fireplace insert.
Guidance on setting air controls, managing fire, and safely refueling the unit.
Procedure for restarting the stove after an overnight or extended burn.
Explanation of how wood quantity affects heat output and efficiency.
Factors affecting chimney draft and its impact on appliance performance.
Instructions for safely removing ashes from the firebox and their proper disposal.
Explanation of creosote formation, risks, and the need for regular inspection and cleaning.
Guidance on identifying, preventing, and responding to chimney fires.
Recommended cleaning procedures for the blower unit to ensure optimal performance.
Instructions for removing the baffle for cleaning and inspecting the chimney liner.
Guide to identifying and resolving common problems like creosote buildup and low heat output.
