EasyManua.ls Logo

Pacific SC8230S - Operating Instructions - SC8230 S;W,SC8236 S;W; 按鍵說明-Sc8230 S;W,Sc8236 S;W

Pacific SC8230S
18 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
VI. Operating Instructions
-SC8230S/W & SC8236S/W
L H
(1) LCD indicate when start lamp function
(2) From off, press one time for bright light (the "H" on the LCD screen will
blink). Press again for dim light (the "L" on the LCD screen will blink).
Press again to power lights off.
(3) The button is not controlled by on / off and delay off.
(1) Press for 3 seconds to start delay off and fan runs at the lowest
speed automatically. The range hood will turn off after 5 minutes.
The on the LCD screen will blink but light is not impacted.
(2) Under this mode, speed can be adjusted. Steam clean is not available.
(3) Under this mode, press the button 2 seconds to stop delay off function;
press on/off to turn off fans.
(4) Fan speed can be changed by pressing this button.
The LCD will indicate fan speed:
(5) When fans are off, press this button and fans will start at last speed
and light when it was last turned off at.
(1) Press to turn on the fans and press again to turn off the fans.
1. On/Off:
2. Light Switch:
3. Delay-off / Fan Speed
(1) Press to start steam cleaning process, when the range hood is cleaning. The
on the LCD screen will illuminate during steam cleaning process.
(2) During the steam cleaning process, the fan speed button is will not
be available.
(3) When water level is low, the on the LCD screen will blink.
(4) Steam clean function will auto-lock if the function senses an error, the
on the LCD screen will blink indicating an error.
4. Steam Clean
1 2 3
1 2 3
(Low)/ (mid)/ (High)
1 2 3
1. 電源/開關按:
(1) 按壓一次開啟風扇再按壓一次關閉風扇
2. 電燈按鍵:
(1) 啟動燈泡時LCD面板顯示
(2) 按第一次全亮LCD面板顯示H按第二次微亮LCD面板顯示L
(3) 此按鍵獨立控制不受電源/開關按鍵和延遲開關按鍵影響
3. 延遲開關/
風速
控制按鍵:
(1) 3秒不放遲關動進風速5
自動關機功能LCD面板以 閃爍顯示但鹵素燈不受影響
(2) 運轉中途可變換風速上下當執行計時中按蒸氣清洗鍵無效
(3) 啟動中按一下延遲開關按鍵2秒會關閉延遲功能電源/開
按鍵會直接關機結束風扇動作
(4) 風速上調控制至高速為止下調控制至低速為按一次
依序遞增或遞減LCD面板分別顯示
(5) 當風扇停止運轉時按風速上或下鍵即以上次關機之速度啟動
4. 清洗按鍵:
(1) 按下開始清洗流程LCD面板顯示 其餘時熄滅狀態
(2) 啟動蒸氣清洗時按風速上下鍵皆無效
(3) 缺水時按此鍵無效且LCD面板以 閃爍顯示警告
(4) 清洗功能異常時會啟動自動鎖定功能LCD面板閃爍顯示
為警示該鎖定功能啟動
L H
1 2 3
1 2 3
(低)/ (中)/ (高)
1 2 3
Steam
Steam
Steam
Steam
六.鍵說
-SC8230S/W & SC8236S/W
9. 9.

Related product manuals