Do you have a question about the Packard Bell iXtreme and is the answer not in the manual?
Provides a general introduction to the disassembly manual for the Stella (iXtreme) chassis.
Guidelines and warnings for authorized technicians performing repairs on the equipment.
General rules and best practices to follow when disassembling the system unit.
Guidance on reversing the disassembly process, ensuring proper component placement.
Lists the necessary tools for performing all disassembly procedures.
Information regarding hazardous voltage present inside the computer even when powered off.
Instructions to avoid damage to electronic components from static electricity.
Warning against disassembling the power supply due to hazardous voltages.
Step-by-step guide to detach the rear protective panel from the computer chassis.
Instructions to remove the left panel of the computer chassis for internal access.
Instructions to remove the right panel of the computer chassis.
Guide to detach the front decorative panel of the computer chassis.
Procedure to remove the bracket holding the optical and floppy disk drives.
Steps to detach the optical drive from its bay.
Instructions to remove the 3.5-inch floppy disk drive from its bay.
Procedure for detaching the hard disk drive from the computer chassis.
Guide to safely remove expansion cards from their slots.
Steps to detach the front panel USB port assembly.
Procedure to remove the power switch and LED indicator assembly.
Instructions for safely removing the Central Processing Unit (CPU) from its socket.
Additional step for removing the CPU heat bracket when a Pentium 4 is installed.
Guide to detach the internal cooling fan from the chassis.
Steps to detach the main circuit board (motherboard) from the chassis.
Procedure to detach the internal power supply unit from the chassis.
Legal disclaimer and copyright information regarding the disassembly manual.
| Brand | Packard Bell |
|---|---|
| Model | iXtreme |
| Category | Desktop |
| Language | English |











