Pacvac Thrift - Troubleshooting; Service Requirements

8
Problem Cause Solution
Backpack not
working
Power cord not firmly plugged into
power point.
Check all plugs and sockets are firmly plugged in.
Backpack shuts off due to high
motor temperature.
Turn main switch off and unplug the backpack.
Conduct safety and maintenance checks found in
this Product and Training Manual or as per labelling
on the machine. After 30 minutes (60 minutes for
wispa) the backpack should be ready for use. If
not contact the number below for your nearest
Authorised Pacvac Service and Warranty Agent.
Circuit breaker or RCD has tripped.
Check the machine is in good working order. If OK,
reset circuit breaker or RCD. If circuit breaker or
RCD trips again contact your nearest Authorised
Pacvac Service and Warranty Agent.
Backpack
has no/poor
suction.
Dust bag is full. Remove, empty and clean dust bag.
Dust bag not installed
Remove and re-insert making sure the rubber
edging is correctly fitted around the canister. For
disposable dust bag ensure it is firmly sealed around
inlet.
Hose not installed correctly. Reconnect hose and ensure correctly sealed.
Blockages.
Remove hose, wand and floor tools; remove any
blockages.
Filters blocked. Replace filter and tap gently to clean.
Caution: Always unplug the backpack before attempting to solve a problem or when servicing.
Troubleshooting
Service Requirements
Our products are designed and built to be functional and durable. For information on use and maintenance
please read this Product & Training Manual thoroughly.
Should you require servicing contact your nearest Authorised Pacvac Service and Warranty Agent.