¡Á
13
[Electric Starter Button]
The sta
rter button is on the right handlebar controls.
1.Make
sure that the gear is shifted to neutral and the fuel switch is in the position of " ", or grasp
the clutch lever to separate the clutch when the motorcycle remains in any other gear.
2. Open the cover of the ignition switch lock, insert the key into switch and turn it 90 degrees
counterclockwise, remove the key and close the lock cover, move the ignition switch 30 degrees
counterclockwise to the internal gear position.
3.Turn the engine cut-off switch to " " and press the electric starter button " ",at the same time,
slightly opening the throttle and the engine will start.
[
Emerg
ency E
n
g
i
ne Cut-off Switch]
Engine
Cut-off is on the right handlebar controls.
" ":In th
is position the engine will turn over but not start.
" ":This is the engine run position.
To start the engine, the engine cut-off switch must be turned to " ".
To Next Page
Loading...