Pagsta BOBBER - Drive Chain Check, Adjustment and Lubrication

To Next Page

To Previous Page

[Driving Chain Cheek]

Check for wear of the drive chain . Lubricate it when

needed. Use the center stand to support the motorcycle, and step

on the gearshift pedal to shift into neutral. Place your finger

between both front and rear wheels, and swing the chain

up and down to adjust the chain to 10-20mm.

(Drive Chain Adjustment)

This motorcycle drive chain adjusts automatically with the

tension of the chain control by tension adapter. Spring will

automatically adjust to the location of the tension wheel. You

should change the tension wheel if it was damaged.

DRIVING CHAIN CHECK, ADJUSTMENT AND LUBRICATION

[Driving Chain Lubrication]

¢Ù

¢Ú

¢Û

Remove a chain lock clip with pliers carefully and disassemble the chain. Clean the

chain with detergent solvent and then dry it. Check for wear and damage of every part of the

chain. If necessary, replace it. Lubricate the chain with an appropriate amount of motor oil

or chain lubricant oil. Install the driving chain in the reverse order of disassembly and

adjust it.

NOTE: WHEN INSTALLING THE CHAIN LOCK CLIP, KEEP THE MOUTH OF THE

CLIP OPPOSITE TO THE NORMAL MOVING DIRECTION.

Tension Wheel