40
1.Uncover and clean the motorcycle.
2.Check the batter voltage. When the voltage is 12.3V or below, you
will need to charge before use.
3
.Drain any rust-inhibiting oil from the fuel tank. Fill the fuel tank
with fresh fuel.
4.Perform all pre-ride i
nspection chec
ks. Test ride the motorcycle in a safe area away from tra
f
fic.
Clean the mot
orcycle off dust and mud with dry cloth reg
ularly. Dry the motorcycle when it is wet.
Apply a little
rust-inhibitin
g oil on zinc-
coated and chrome-coated parts. Wax the pa
inted parts to
keep
them
looking new. Lubricate all moving Parts.
Inflate both tires to their recommended pressures.
Che ck all bolts, nuts and screws to prevent a safety hazard resulting from loosening.
Check both front and rear brakes. Immediately adjust and replace if they are excessively worn or don't
function properly.
Perform the pre-ride inspection at each scheduled maintenance period.
Symbols in the table stand for as follows:
1.INSPECT, CLEAN, ADJUST, LUBRICATE OR REPLACE IF NECESSARY.
C:CLEAN R:REPLACE A: ADJUST L:LUBRICATE I:INSPECT
* Should be serviced by your authorized PAGSTA dealer.
** I n the interest of safe ty, we recommend these items be serviced only by your authorized service dealer.
REMOVAL FROM STORAGE
MAINTENANCE
MAINTENANCE SCHEDULE
To Next Page
Loading...