P2 User Manual Version 1.0
13
Email Commands
You can send control commands to the P2 using E-mail. When sending an email, make sure that only plain
text is used. The subject of the email should have “rcs” and the body of the email should be as follows:
username
password
Command
By default the “username” and “password” are pakedge and pakedgep.
The “command” is what you tell the P2 to do. For example, if you want to turn off all the ports on the P2 you
would compose the email using the following:
From:xxx@xxx.com
To: Email setup on the P2
Subject : rcs
pakedge
pakegep
ps 0
To get a list of commands supported by the P2, you can Telnet and issue the command “help”.
To Next Page
Loading...