P2 User Manual Version 1.0
3
Installation
Rack Mount Instructions
A) Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, make sure
the P2’s operating temperature is below the manufacturer’s specifications.
B) Reduced Air Flow – The P2 should be installed in a rack with proper air flow for safe
operations.
C) Mechanical Loading – Do not place heavy objects on top of the P2. Damage due to
mechanical loading could create a hazardous condition.
D) Circuit Overloading – Do not overload the circuits. Please read and follow all
manufacturers’ directions.
1. Installing the Side Rack Brackets or mounting to a wall
The P2 comes with two brackets to mount on a rack. To mount the P2 use the following steps:
a) Attach the mounting brackets to the sides of the unit using the screws provided for
each of the brackets. The bracket is equipped with 8 screw holes which gives different
options for how to connect the brackets to the unit.
b) Align the mounting holes of brackets with the notched hole on the vertical rail and
attach with the retaining screws.
c) The P2 can also be mounted to a wall using the built in mounts.
2. Connect input power.
3. Connect Ethernet cable to the P2 and the other end to an Ethernet switch.
4. Connect your devices to the outlets on the P2. You may use any outlet, as there are no
required locations for any device.
5. Switch on the P2.
To Next Page
Loading...