Setting up the machine
7
Subject to change without notice
29
Adjust lower round belts of shaft 2:
1. Set the lower belts exactly below the upper belts.
Obere Rundriemen der Welle 3 einstellen:
Ö The products are driven along the course of the round belts. Set the round
belts of shaft 3 so that there is an exact allocation to the relevant shaft.
1. Align belt (2) to the transport belt (1).
Ö see picture 1040837
2. Align both outside belts parallel to each other. In doing so, pay attention to the
number of grooves on round belt shaft 1.
3. Use the number of grooves to adjust both outer belts. This will ensure that the
product is not fed in at an angle.
Round belt adjustment
Abb. 1040837
1 Transport belt 3 Photocell
2 Round belt
Wrong
Adjust lower round belts of shaft 4:
1. Place the lower belts exactly under the upper belts.
2. Repeat these steps for all up-works of the product.
2
1
3
To Next Page
Loading...