Palas CD 2000 Type A - 2 Safety Conditions; Intended Use; General Safety Conditions; Intended Use; Responsibility of the Operator

To Next Page

To Previous Page

OPERATING MANUAL CD 2000

Palas

GmbH, Karlsruhe, Version V002022014

2. Safety conditions / Intended use

2.1 General safety conditions

 For safety reasons, under no circumstances may the machine be commissioned if there

is visible damage. In this event, please contact Palas® (Tel.: 0721/96 213-0).

 The discharge system CD 2000 has been permanently adjusted by the manufacturer to

the mains voltage requested in the order. Please verify, if the mains voltage indicated on

the type label corresponds to the mains voltage at the respective place of instalment.

Attention: The manufacturer is not reliable for any damages caused by another voltage

supply as stated on the instrument

 Only use original spare parts! Please contact the manufacturer whenever necessary.

2.2 Intended use

 The discharge system CD 2000 was designed to create a soot similar to diesel soot by

graphite electrodes and to disperse this soot into air/ gas stream.

 The manufacturer is not responsible for any damage, which arise due to incorrect

operation, cleaning, error in operation or the measurement of aerosols which gas

conditions or compound the instrument is not specified for.

 The machine may only be operated in dry rooms, under atmospheric ambient pressure

and at room temperature.

Operating under other ambient conditions such as in corrosive or explosive

environments, in strong electric or electromagnetic fields, in areas with ionising

radiation as well as in areas subject to impact and vibration is not covered by any

functional guarantee by the manufacturer

2.3 Responsibility of the operator

 The device was designed and built in consideration of the standards to be adhered to. It

therefore represents state-of-the-art technology and allows a high degree of safety in

operation.

 Please only operate the dust disperser of the discharge system CD 2000 after reading

carefully the manual.

 Trained personal

 Be sure that the machine cannot be used by unauthorized personnel.

 Caution: Depending on the type, aerosols can pose a health hazard. They should

therefore not be inhaled. When working with or when around hazardous materials, care

must also be taken to wear appropriate protective clothing (respirator mask). Please

follow all applicable guidelines and accident prevention regulations.