Palfinger ILK 33 - Check Off Sheet

ILK 22/33/44/55/66 INSTALLATION MANUAL
Revision 1.6 - 47 -
Check Off Sheet
JOB NO.
GATE NO. VIN NO.
OWNER'S MANUAL IN CAB
ON-OFF SWITCH WORKING & DECAL IN PLACE
WIRING 1. Power Cord Secured OPERATION 1. All Functions Operate On
2. Cables Not Rubbing Steel outside Control & Hand Control
3. 12V Control Wire Secured 2. Up Stops In Place
4. Loomed & Stapled 3. Platform Meets Body
5. Circuit Breaker & Fuse 4. Sensor Set For Proper
Installed & Decal In Place Auto tilt
6. Loop in platform sensor wire 5. Warning lights stop flashing
when platform stored
HYD. LINES 1. No Rubbing On Frame 6. Cab switch not flashing when
SECURED 2. No Rubbing On Platform platform stored and switch off
3. Up-Down Clear 7. Platform hits rear sill even
4. Storing Platform Clear at the same time
8. Titl cylinder clevis
HYD. OIL 1. None At Hoses lock nuts tight
LEAKS 2. None Power Pack 9. No Paint on cylinder shafts
3. Cylinders
FINAL 1. Platform Touches Ground
WELDS 1. Full Welds Mount Plates INSPECTION 2. Lights Working On Chassis
2. Ground Off / Clean 3. Lic. Plate Bolts & Lights
3. Frame Capped Off 4. Decals Installed
5. Rubber & Plastic Caps on
6. Gate Painted Completely
7. Body Clean Around Gate
PUMP 1. Check Fluid With Platform On Ground 8. Pin Greased - 12 Places
& MOTOR 2. Connections Tight With Heat Shrink 9. Cylinders Clean
3. Power Cable Tight 10. Clamp on cover
4. Ground Cable Tight 11. Exhaust mud flaps are ok
5. Breather Installed
6. Cables Tied Off OPTIONS 1. All Options On Gate
7. Fuses Tight 2. Circuit Breaker Tight
8. Clamp on cover 3. Cart Stops Working
PINS 1. Grease Zerks In Place CHECKED BY
2. Red Grease Caps On Zerks
DATE
3. Bolts Tight On Pins
4. Ground Rollers On
Note:
This must be filled out and kept for your records. A copy of this sheet must be
presented to Interlift for any warranty compensation
Note:
This must be filled out and kept for your records. A copy of this sheet must be present-
ed to PALFINGER Liftgates for any warranty compensation.