Need help?Do you have a question about the Panametrics MG2-XT and is the answer not in the manual?
General| Brand | Panametrics |
|---|---|
| Model | MG2-XT |
| Category | Measuring Instruments |
| Language | English |
Details of the product warranty coverage and limitations.
Step-by-step guide for the initial setup of the gage.
Explains the zero compensation step for transducers.
Steps for performing thickness measurements.
Calibrates for sound transit time and temperature variations.
Calibrates for material sound velocity using test blocks.
Calibrates for best absolute accuracy using thin test blocks.
Detailed steps for transducer zero compensation.
Combined procedure for velocity and zero calibration.
Procedures for calibrating material velocity.
Steps to calibrate velocity when material speed is unknown.
Steps to calibrate velocity when material speed is known.
Procedure for performing zero calibration.
Calibration for measuring metal thickness with coatings.
Calibrates for metal thickness, ignoring coating thickness.
Calibrates for both metal and coating thickness.
Calibrates for measuring wall thickness ignoring paint/coatings.
Procedure to calibrate the Echo-to-Echo feature.
Features related to the internal datalogger.
Setting high and low alarm thresholds.
Steps to activate High/Low Alarms.
Resets measurement parameters to defaults.
Steps to perform measurement resets.
Resets instrument and deletes database.
Steps to perform master resets.
Clears the entire database.
Steps to perform database resets.
Adds advanced measurement features.
Viewing live ultrasonic waveform.
Adjusting setup parameters not in Standard Mode.
Adjusting gain in 1 dB increments.
Extending the blank from sound entry point.
Blocking noise signals between backwall echoes.
Adjusting the waveform range.
Introduction to the datalogger and its functions.
How to store displayed thickness values.
Downloading data from computer and using GageView.
Downloading data from computer to gage.
Using the GageView software for data management.
Explains the sound wave timing and reflection principle.
Factors influencing measurement performance.
Impact of surface condition on measurements.
How to properly position and align transducers.
Importance of accurate calibration for measurement accuracy.
Guidance on selecting appropriate transducers.
Special considerations for high temp measurements.
Explains special error messages displayed by the gage.
Troubleshooting issues related to power and battery.
Troubleshooting the "Do--" message.
Troubleshooting issues when measurements fail.
Using diagnostic screens to identify problems.
Steps to view diagnostic results.
Steps to view diagnostic results.
Tests the functionality of keypad keys.
Steps for performing the keypad test.
Tests the functionality of display pixels.
Steps for performing the video display test.
Information on how to get the unit repaired.
To Next Page
