Activating/inactivating the remote access code
t
o play messages
If you activate this feature, you must enter the
remote access code (page 59) to play the new
message from the new message alert call. This is
so that unauthorized parties cannot listen to your
messages. The default setting is “Inactivate”.
– “Inactivate”: You can listen to the message
by pressing 4 to play new messages (without
entering the remote access code).
– “Activate”: You must enter your remote
access code (page 59) and then press 4 to
play new message.
Handset / Base unit
1 F
or line 1: MMENUN#3381
For line 2: MMENUN#3382
2 MbN: “Remote code” a MSELECTN
3 MbN: Select the desired setting. a MSAVEN
4 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Listening to messages
A
fter you answer the new message alert, you can
listen to the messages as follows.
n When the remote access code is set to
“Inactivate”:
Press 4 to play the new message during the
announcement.
n When the remote access code is set to
“Activate”:
1 Enter the remote access code (page 59)
during the announcement.
2 Press 4 to play the new message.
Note:
R Within 10 seconds after listening to new
messages, you can press #9 during the call
to turn off the new message alert by a call
feature.
R Even if the unit makes a new message alert call,
the handset redial list does not show the record.
However, on the base unit redial list it is shown
as “Message alert”.
Remote operation
U
sing a touch-tone phone, you can call your
phone number from outside and access the unit to
listen to messages or change answering system
settings. The unit’s voice guidance prompts you to
press certain dial keys to perform different
operations.
Remote access code
A
3-digit remote access code must be entered
when operating the answering system remotely.
This code prevents unauthorized parties from
listening to your messages remotely. The default
setting is “111”.
Program this setting using either the base unit or
one of the handsets.
Important:
R To prevent unauthorized access to this product,
we recommend that you regularly change the
remote code.
Handset / Base unit
1 F
or line 1: MMENUN#3061
For line 2: MMENUN#3062
2 Enter the desired 3-digit remote access code.
3 MSAVEN
4 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Deactivating remote operation
P
ress * in step 2 on “Remote access code”,
page 59.
R The entered remote access code is deleted.
Using the answering system remotely
1 D
ial your landline phone number from a
touch-tone phone.
2 After the greeting message starts, enter your
remote access code.
3 Follow the voice guidance prompts as
necessary or control the unit using remote
commands (page 60).
4 When finished, hang up.
For assistance, please visit http://shop.panasonic.com/support
59
Answering System for Landline
To Next Page
Loading...
