Panasonic 2-LINE KX-TG9551 Series - Getting Started; Setting up

Setting up
Connecting the AC adaptor
n
Base unit
Connect the AC adaptor plug to the unit until
y
ou hear a click.
Connect the AC adaptor to the power outlet.
N
ote:
R Use only the supplied Panasonic AC adaptor
PNLV234.
1
2
R F
ollow the directions on the display to set up
the unit.
n C
harger
Connect the AC adaptor to the power outlet.
1
Connecting the telephone line cord
R
efer to one of the following methods depending
on your situation:
– To connect to a 2-line telephone jack: page 9
– To connect to 2 single-line telephone jacks:
page 9
– If you use the unit as a single-line telephone
only: page 9
Connect the telephone line cord until it clicks into
the base unit and telephone line jack.
To connect to a 2-line telephone jack
Connect the “G
REEN” plug telephone line
cord (4-wire cord) (
1
) to the unit, then to the
2
-line telephone jack (RJ14C) (
2
) until you
h
ear a click.
1
1
2
“GREEN” plug
To connect to 2 single-line telephone jacks
For Line 1: Connect the “Transparent” plug
t
elephone line cord (2-wire cord) (
1
) to the
u
nit, then to the Line 1 single-line telephone
jack (RJ11C) (
2
) until you hear a click.
For Line 2: Connect the “G
REEN” plug
telephone line cord (4-wire cord) (
3
) to the
u
nit, then to the Line 2 single-line telephone
jack (RJ11C) (
4
) until you hear a click.
2
4
3
12
1
“Transparent” plug
“GREEN”
plug
If you use the unit as a single-line telephone
o
nly
Be sure to connect the telephone line cord to LINE
1/2. Change the line selection mode from “Auto”
to “Line1” (page 17).
Connect the “Transparent” plug telephone line
c
ord (2-wire cord) (
1
) to the unit, then to the
s
ingle-line telephone jack (RJ11C) (
2
) until
y
ou hear a click.
1
1
2
“Transparent” plug
For assistance, please visit http://shop.panasonic.com/support
9
Getting Started
KX-TG954x_955x_OI(en)_0507_ver432.pdf 9 2018/05/07 14:00:40