Panasonic AG-7330 - Interface Adaptor (Option)

| INTERFACE ADAPTOR (Option)
The units listed in the table below can be connected to this VTR if their corresponding Interface Adaptors are installed in the remote
control connector’s section.
Interface Adaptor Model No. Connectable Units (option)
RS-232C Interface Adaptor AG-1A232 ®AG-A730
34P Interface Adaptor AG-IA34 @AG-A750 @AG-A650 e@NV-A500
e@NV-A960 @NV-A505 @AG-A600
The Dip Switches 2~7 under RS-232C Interface are as shown
below.
(Dip Switches 1 and 8 are not used.)
@Stop Bit Parity
Tae Ton]
re00 | oFF | on
eBit Length
2. Connect the desired Interface Adaptor.
Note:
Be sure to piug the cable of the VTR into the Interface
Adaptor as shown below.
Plug in the cable into
the interface Adaptor.
When the VTR is connected to the optional Remote Controller
AG-A730, the operation buttons, mode selection, dial function,
etc. can be remote controlled.
For details about AG-IA232, please contact your authorized ©
local dealer.
3. Tighten up the screws. eSignal of Connector (25P)
RS-232C Interface Adaptor
e09e000o000c000
© AG-IA232
—— oe
fe [po T=
© AS-292C intertace Adaptor AG-1AZ32 O
rs [aoe far
cease ow
Ps fos ef J
Pe[— ister
*1: Depending on the connection, pin No. 9, 10, 25 maybe no
connection. For details, please contact your authorized
Ae
H
A
Ba
A
H
local
dealer.