Panasonic AG-7330 - Rack Mount Adaptor (Option)

RACK MOUNT ADAPTOR (Option)
This adaptor (AG-M730) is used to mount the AG-7330 on
the IEC 19” standard rack.
eUse the IEC 19” standard rack.
Use a compiete slide rail and bracket unit for 18” length (part
No. CC3004-99-0017) or 24” length (part No. CC3004-99-
0018) of Chassis Trak.
Accessories
Screws (for slide rails) M4.............. ccc cee cece 4pcs.
Installation of Rack Mount Adaptor
Remove the screws on the recorder side. Then use the M4
screws (supplied) to install the Rack Mount Adaptor.
1
Install it with the
notch down
Mounting onto the rack
eRemove the rubber legs (4 pcs.) from the bottom of the
recorder.
eWhen mounting the recorder on the rack, be sure to install a
ventilation fan (air volume of about 3.3 m*/sec.) on top of the
rack.
IEC standard rack
Fasten it to the
rack with
setscrews.
When using the slide rail, remove
the setscrews. The setscrews can
be removed by pulling in the
direction of the arrow. Keep the
remove setscrews, washers and
spacers in a proper place.
—46—
Installation of slide rails
Use a complete slide rail and bracket unit for 18” length (part
No. CC3004-99-0017) or 24” length (part No. CC3004-99-
0018) of Chassis Trak.
(The complete slide rail and bracket unit is not available from
Panasonic.)
®For the details, contact your local dealer.