Panasonic AG-7330 - Page 48

TROUBLE SHOOTING
If there is no power to the unit
If no operation starts when either the @{s the small tab (removable tab) on the back of the tape still intact? 43
Record or Audio Dubbing Button is
pressed els the TV SYSTEM Selector set correctly (“PAL” or “CCIR")? 16
\f no change in counter display els the control (CTL) signal recorded on the tape? 6
els the tape counter mode set to “COUNT” mode? 6
Conditions
Inspection and Adjustment
els the Power Plug inserted?
els the unit in the AUTO OFF mode? 47
e@Are the connections correct?
® Have all the switches been set properly?
lf still no power after checking the “Inspection and Adjustment” above,
turn the power OFF for a few minutes and to ON again.
If the tape remaining time is not correct | els the TAPE Selector (ON-SCREEN mode) set to the correct position? 12
If record (or playback) mode is engaged | els the Timer Selector set to “OFF”? 16, 19
when the Power is turned ON
ets the SENSOR REC Switch set to “ON”? 8
If the cassette tape cannot be inserted @ls the Power Switch set to “ON’? —
or removed
If the playback image is completely els there a supply voltage fluctuation during recording? —
distorted
[ed
If no operation with button pressed ®\s the video cassette inserted correctly? —
els the “ qo ” mark in the tape counter flashing? 47
els the OPERATION Selector set to “LOCAL”? 8
els the SENSOR REC Switch set to “ON"? 8
| oe na en eer ee ee eee ee |
If recording is discontinued Check if video cassette tape is at the end. —
If auto repeat playback is not possible
els horizontal hold control of TV monitor set correctly? —
ls the cassette tape in good condition? —_—
els the Sync Mode Selector set correctly? 8
els the TV SYSTEM Selector set correctly? 19
eCheck if more than 5 minutes has passed after pressing Pause/Still
Button during recording.
eCarry out the daily maintenance sufficiently.
There must be something wrong if this kind of trouble takes piace often. 47
In that case, contact your authorized local dealer.
Check that COUNT REPEAT or VASS REPEAT (ON-SCREEN mode}
is “1 TIME” or “CONTINUE”.
Was the STOP Button pressed during auto rewind mode?
—48—