- 99 -
This will reduce the wind noise coming into the built-in microphones while maintaining the realism.
≥ Set the [MIC SETUP] to anything other than [2ch]. (l 45)
≥ You may not see the full effect depending on the recording conditions.
Recording setting of the built-in microphone can be adjusted. (l 45)
When recording, the input level from the built-in microphones can be adjusted. (l 49)
Change the lower setting of the built-in microphone (5.1 ch) according to your choice.
≥ Set the [MIC SETUP] to [SURROUND] or [ZOOM MIC]. (l 45)
≥ Normally set to [0dB].
≥ Select [+3dB] or [+6dB] to get strong power feeling at bass level.
≥ Set [MIC SETUP] to [2ch]. (l 45)
Distortion of the sound can be reduced when the built-in microphone (2 ch) or external microphone
is used by setting to [ON]. ( is displayed on the recording screen) It will record with natural
sound when set to [OFF].
≥ Adjust the audio control knobs (CH1, CH2) to adjust the audio input level.
Sets the input level of the external microphone connected to the audio input terminal 1 (XLR 3 pin).
Sets the input level of the external microphone connected to the audio input terminal 2 (XLR 3 pin).
[WIND NOISE CANCELER]
[ON]/[OFF]
[MIC SETUP]
[SURROUND]/[ZOOM MIC]/[FOCUS MIC]/[2ch]
[5.1ch MIC LEVEL]
[AUTO]/[SET]/[SETr ]
[BASS SETTING]
[0dB]/[+3dB]/[+6dB]/[LOWCUT]
[2ch MIC ALC]
[ON]/[OFF]
[EXT. MIC GAIN1]
[-50dB]/[-60dB]
[EXT. MIC GAIN2]
[-50dB]/[-60dB]
AG-AC90A-SQT0333_mst.book 99 ページ ２０１４年５月１４日 水曜日 午前１０時３６分
To Next Page
Loading...
