Direct Selection of Default Config
If no custom configurations have been made on the RCPv2
you will be presented with this interface
Selection of Default Config
If custom configurations have been made on the RCPv2 you
will be presented with this interface
Select the “Panasonic AU-EVA1” config in the drop down list. This will
load the configuration on the configuration page. Then go to the
Firmware Application and press “Check for updates”.
This will generate a firmware file on our server and download it to the
controller.
Notice on Windows the Port dropdown will display “COM” ports.
Please see section “Port selection on Windows” in Installation and
Operation manual https://www.skaarhoj.com/support/manuals/
Select the “Panasonic AU-EVA1” config and then go to the Firmware
Application and press “Check for updates”. This will generate a
firmware file on our server and download it to the controller.
If you want to use different IP addresses then alter “Network
configuration” and press “Save Network Configuration” and then
press “Check for updates” in the Firmware Application
Notice on Windows the Port dropdown will display “COM” ports.
Please see section “Port selection on Windows” in Installation and
Operation manual https://www.skaarhoj.com/support/manuals/
To Next Page
Loading...
