Chapter 11 Specification — Specifications
- 205 -
Handle unit
USB ethernet adaptor ([CX10] supplied)
AC adaptor
Battery pack (AG-VBR59)
Power consumption
Maximum approx. 3.1 W (when connected to the camera)
Mass Approx. 305 ] (main part of the handle unit only, excluding microphone holder and microphone holder
mounting screws)
External dimensions (W×H×D) Approx. 71 mm×89 mm×207 mm (
including protrusions, excluding microphone holder)
Power
5 V (power supplied via USB bus)
Power consumption
Approx. 80 mW (when communicating with the camera at the maximum bit rate)
USB interface Standards followed Conforms to USB3.0/2.0/1.1
Terminal USB3.0 Type A
LAN interface Standards followed Conforms to IEEE802.3ab (1000BASE-T), conforms to IEEE802.3u (100BASE-TX), conforms to
IEEE802.3 (10BASE-T)
Transfer speeds 1000 Mbps/100 Mbps/10 Mbps
Connector shape RJ-45, 8 plug connector
Mass Approx. 30 ]
External dimensions (W×H×D) Approx. 24 mm×14.5 mm×64 mm (main unit only, excluding cable parts)
Cable length Approx.140 mm
Ambient operating temperature 0 °C to 50 °C
Ambient operating humidity 5% to 90% (relative humidity, no condensation)
Power source
100 V – 240 V 50 Hz/60 Hz, 1.2 A 79 VA (100 V ) – 99 VA (240 V )
Power output
12 V 3.0 A
Ambient operating temperature 0 °C to 40 °C
Ambient operating humidity 10% to 90% (relative humidity, no condensation)
Mass Approx. 225 ]
External dimensions (W×H×D) 115 mm×37 mm×57 mm (excluding the DC cable section)
Voltage/capacity
7.28 V 5900 mAh 43 Wh
Charging current Maximum 4000 mA
Ambient operating humidity 0% to 80% (relative humidity, no condensation)
Mass Approx. 230 ]
External dimensions (W×H×D) 41.3 mm×51.3 mm×69.6 mm