Chapter 4 Operation — Menu settings
- 90 -
[SERVICE MODE]
Switches the unit to the service mode.
You can also check software information (licenses) on a computer and other equipment. Confirm “LICENSE.TXT” for the external drive recognized by a
computer.
The items that can be selected are as follows.
≥ [YES], [NO]
0 When switched to service mode while using a battery, the LCD monitor turns off after approximately 5 seconds.
The LCD monitor turns on when you perform the following operations:
j Turn the multidial up or down
j Touch the LCD monitor
0 To exit the service mode, do one of the following operations:
j Turn the power off
j Press the <EXIT> button
j Press the multidial
j Touch [ ]
[INFORMATION]
[VERSION]
Displays the information of the unit.
[OPERATION TIME]
Displays the total operation time.
[UPDATE]
Updates the firmware.
Insert the memory card where the update file is saved into card slot 1.
The items that can be selected are as follows.
≥ [YES], [NO]
[ECO MODE]
By setting [OTHERS] menu → [ECO MODE] → [BATTERY]/[AC]/[NETWORK], when there is no button operation or LCD monitor touch operation
performed for a certain time, the power turns off automatically.
0 In the following cases, even if [BATTERY], [AC], or [NETWORK] is set to [ON], the power will not automatically turn off.
j While a memory card is being accessed (during recording, during playback, while formatting the media, etc.)
j During pre-recording
j In card reader mode
0 In the following case, even if [BATTERY] is set to [ON], the power will not automatically turn off.
j When using the AC adaptor
*
0 In the following cases, the power will not automatically turn off.
j When connected to a network via wireless LAN or wired LAN
* The power turns off automatically if the [AC] eco mode functions.
[BATTERY]
When about 5 minutes have passed without any operation, this unit automatically turns off to save battery life.
The items that can be selected are as follows.
≥ [ON], [OFF]
(Factory setting: [OFF])
[AC]
If there are no operations for approximately 15 minutes while using the AC adaptor, the power turns off automatically.
The items that can be selected are as follows.
≥ [ON], [OFF]
(Factory setting: [OFF])
[NETWORK]
If there are no operations for approximately 15 minutes when the [NETWORK] menu → [DEVICE SEL] → [WLAN] or [USB-LAN] is set while not
connected to the network via a wireless LAN or a wired LAN, the power turns off automatically.
The items that can be selected are as follows.
≥ [ON], [OFF]
(Factory setting: [OFF])
[MODEL] Displays the product name of the unit.
[SERIAL NO.] Displays the serial number of the unit.
[VERSION] Displays the firmware version of the unit.
To Next Page
Loading...
