38
Main Mode: Thumbnail Screen
Select the clips you want to process on the thumbnail screen.
1 Use the cursor buttons to align the yellow frame (cur-
sor) with the target clip.
Note:
Press the [TOP] or [BOTTOM] button to move the cursor to the
first or last clip.
2 Press the [SET] button.
A light blue frame and 9 appear on the clip selected with
the cursor to indicate that it is selected.
Note:
• Repeat steps 1 and 2 to select multiple clips.
• Select a clip, move the cursor to another clip, and press the
[SET] button while holding down the [SHIFT] button to select
all of the clips from the clip selected first to the cursor posi-
tion.
• Selecting a clip updates the number of selected clips indi-
cated at the bottom right of the screen.
1 Align the cursor with a selected clip and press the
[SET] button again.
The selection is canceled.
Note:
Press the [CANCEL] button to deselect all of the selected
clips.
A text memo can be added to a clip to mark a specific location
of the clip. You can also add a shot mark to a clip to distin-
guish it from other clips. A text memo or shot mark cannot be
added to a clip on a P2 card with the write-protect switch set
to Protect.
When a text memo is added, you can display a thumbnail at
the text memo position for playback or copying and seek
(move to) the text memo position by pressing the [NEXT] or
[PREV] button during video playback.
(➝ Setup Menu “SEEK POS SEL” page 87)
1
Assign “TEXT MEMO” to any [USER] button.
It is assigned to USER3 by default.
(➝ Setup Menu “USER BUTTON” page 99)
2 Press the [USER] button to which “TEXT MEMO” has
been assigned during recording, playback, or thumb-
nail display.
• Press this button during recording or playback to add a
text memo at the position the button was pressed. The
OSD displays “TEXT MEMO” (when successful) or “IN-
VALID” (when adding was not possible).
• Pressing this button when the thumbnail screen is dis-
played adds a text memo at the position of the clip
thumbnail (normally the beginning).
Note:
• Up to 100 text memos can be added to one clip.
• Pressing the [USER] button to which “TEXT MEMO” has
been assigned during playback may temporarily freeze the
playback screen. This is normal and not a malfunction.
• Text memos cannot be recorded during loop recording.
Changing the thumbnail screen to the text memo display al-
lows you to delete text memos.
1 Change the thumbnail screen to the text memo dis-
play.
Select “TEXT MEMO CLIPS” in the “REPOSITION” (➝
page 82) menu item.
2 Use the cursor buttons to move to the thumbnail for
which you want to delete the text memo and press
the [SET] button.
The cursor moves to the bottom.
Selecting and Deselecting Clips
Selecting clips
Deselecting clips
Adding Text Memos and Shot Marks
Adding text memos
Deleting text memos
To Next Page
Loading...
