78
Time Code, User Bits, and CTL:
7 When you finish setting the start values, press the
[SET] button.
When the “RUN MODE” (➝ page 88) menu item is set to
“FREE RUN,” the time code starts advancing immediately.
To cancel this setting, press the [EXIT] button or [CAN-
CEL] button.
Time code when no power is supplied
When no power is supplied, the backup function works to en-
able the time code generator to provide long-term (about
three months) operation.
Note:
When the setting of the “SYSTEM MODE” - “LINE&FREQ” (➝
page 105) menu item is changed, the run data is cleared.
1 Press the [STOP] button to switch to stop mode.
2 Use the [COUNTER] button to select “TC.”
3 Set the “TCG MODE” (➝ page 88) and “UBG MODE”
(➝ page 88) menu items to “EXT.”
(External time code selection)
4 Select the external input time code type in the “EXT
TC SEL” (➝ page 89) menu item.
Note:
When “SLTC” or “SVITC” is set and “SD SDI” is selected as the
input signal, the VITC of the input video signal is recorded.
External mode
EXT LTC: Records the LTC signals input to the
TIME CODE IN connector (BNC) on the
rear panel.
SLTC: Records the LTC signals added to the se-
rial signals input to the SDI IN connector.
SVITC: Records the VITC signals added to the
serial signals input to the SDI IN connec-
tor.
To Next Page
Loading...
