How to set up the system
Configuration example 1: Connection of camera controller
Use multi cable supplied with AK-HRP150 for the connection of camera controller
AK-HRP150 and this unit.
Before connecting the cables, be sure to set the power switch of AC adapter to OFF.
Connect the multi cable to the interface connector of the camera, and the opposite
side to camera controller.
Set the AC adapter power switch to ON, then the camera can be controlled.
After shooting, set the AC adapter power switch to OFF.
Multi cable
(POWER + CONTROL)
Lens
Camera controller
AK-HRP150
AC adapter
AW-PS505A
Monitor
HD SDI OUT
IRIS
AK-HC1500
Select “1” as the PROTOCOL
setting.
To Next Page
Loading...
