13
A file with the same name already exists. Select [y]
to overwrite.
An error occurred on the memory card.
• Check if a file with the same name already exists.
• Check if the memory card is write protected.
• Check if there is any free space left on the P2 card.
A memory card has not been inserted.
• A communication error occurred. Check the
connected equipment.
• The lens file is off.
An error occurred. Start over from the beginning.
[E01] is displayed when a file with the same name as the one you are
attempting to save already exists on the memory card.
To overwrite the file, press <UP> or <DOWN> to select [y] and press
<EXECUTE>.
Press <EXECUTE> to close the error message. Then perform the
operation again.
To Next Page
Loading...
