9
CAMERA
No.
DATA
SET
DISPLAY SELECT
UP
DOWN
SET UP
ND/CC M.GAIN/M.PED
SHUTTER
ND
M.GAIN
IRIS
M.PED 10-19
CC SHT SYNC
SELECT
EXECUTEEXIT
SAVE/LOAD
SHIFT
+
UP+DOWN
Select file number,
Select y (Select)/
n (Cancel)
Save file indication
Load file indication
Press to select the
menu number
Press to exit setup mode
(hold down)
Press to confirmPress to save/load
• Each press of <SAVE/LOAD> toggles between [ND] (Save) and
[CC] (load).
ND
M.GAIN
IRIS
M.PED
CC SHT SYNC
ND
M.GAIN
IRIS
M.PED
CC SHT SYNC
To save a file to file no. 2 on the memory card
• Do not remove a memory card that is being accessed.
ND
M.GAIN
IRIS
M.PED
CC SHT SYNC
• To cancel saving, select [n] and press <EXECUTE>.
• The file is saved to the memory card and [Fin] appears when saving
ends.
• [E02] is displayed if the save operation to the memory card fails.
(→page 13)
If this happens, check the memory card and try again or insert
another memory card to perform the operation again.
• [E01] is displayed when a lens file with the same name as the one
you are attempting to save already exists on the memory card.
To overwrite the file, press <UP> or <DOWN> to select [y] and
press <EXECUTE>.(→page 13)
• [E04] is displayed when the lens file is off.
• To exit setup mode, hold down <EXIT> for about 2 seconds.
• To make other settings, press <SELECT> to select a menu number.
• Each press of <SAVE/LOAD> toggles it between [ND] (Save) and
[CC] (Load).
ND
M.GAIN
IRIS
M.PED
CC SHT SYNC
ND
M.GAIN
IRIS
M.PED
CC SHT SYNC
To load file no. 2 from the memory card
• Do not remove a memory card that is being accessed.
ND
M.GAIN
IRIS
M.PED
CC SHT SYNC
• To cancel loading, select [n] and press <EXECUTE>.
• The file is loaded from the memory card and [Fin] appears when
loading ends.
• [E02] is displayed if the load operation from the memory card fails.
(→page 13)
If this happens, check the memory card and see whether the file
exists on the memory card. If it does, start over from step 1.
• [E04] is displayed when the lens file is off.
• To exit setup mode, hold down <EXIT> for about 2 seconds.
• To make other settings, press <SELECT> to select a menu number.
CAMERA
No.
DATA
SET
DISPLAY SELECT
UP
DOWN
SET UP
ND/CC M.GAIN/M.PED
SHUTTER
ND
M.GAIN
IRIS
M.PED 10-19
CC SHT SYNC
SELECT
EXECUTEEXIT
SAVE/LOAD
SHIFT
+
UP+DOWN
Select y (Select)/
n (Cancel)
Save file indication
Load file indication
Press to select the
menu number
Press to exit setup mode
(hold down)
Press to confirmPress to save/load
To Next Page
Loading...
