Panasonic Aquarea WH-UD09JE5-1 - Model Code

25
Aquarea air-to-water heat pumps - Planning and installation manual - 02/2022
Product Description
4
Aquarea High Performance Aquarea T‑CAP Aquarea HT
Control and connectivity
Smart Grid Contact
6
Wireless LAN Ready
Smart Grid Contact
6
Wireless LAN Ready
Smart Grid Contact
6
Range
All in One from 3 to 16 kW (185 L)
Bi-bloc from 3 to 16 kW
Mono-bloc from 5 to 9 kW
All in One from 9 to 16 kW (185 L)
Bi-bloc from 9 to 16 kW
Mono-bloc from 9 to 16 kW
Bi-bloc from 9 to 12 kW
Mono-bloc from 9 to 12 kW
Note: All data in this chart is applicable in most of models in each line up, check product specs to conrm.
1 Scale from A+++ to D
2 9 and 12 kW
3 DHW maximum temperature with heater.
4 In case of outdoor temperature over -10 °C.
5 It is possible to set temperature to 65 °C on remote controller. Normally, outlet water temperature is 60 °C or lower. In
case of ΔT setting with remote controller is 15 °C and the outdoor ambient temperature is 5 to 20 °C, outlet water tem-
perature 65 °C is possible.
6 J and H Generation with CZ-NS4P, F and G Generation with Heat Pump Manager.
Besides the notable di󰀨erences as in mono-bloc and bi-bloc systems or hydrokit and All in One
unit, all models have the same working principle and can therefore be described together in respect
of many planning-relevant properties. The relevant di󰀨erences, even those between di󰀨erent
product generations, will be pointed out at the appropriate point.
4.5.3 Model code
For easy and clear denomination of the di󰀨erent Aquarea models, a model code is used, from
which the models with their respective specic properties and functions can be read o󰀨.
Example
WH-MDC05J3E5 is a heat pump unit (WH-) in mono-bloc design (M) of the High Performance
series (D) with cooling function (C), a nominal power of 5 kW (05) of the J generation (J) for the
European market (E) with a single phase power supply (5).
Model code for All in One indoor units (bi-bloc systems)
Device type
WH: Air-to-water
heat pump
Construction
A: All in One indoor unit (hydrokit and
hot water tank of the bi-bloc systems)
Series D: Aquarea High Performance / Aquarea T-CAP
Operating mode C: Heating and cooling
Nominal
heating capacity
1
0309: 3, 5, 7 or 9 kW, 0916: 9, 12, or 16 kW, 1216: 12 or 16 kW
Device
generation
2
... H, J ...
Backup heater
capacity 3: 3 kW, 6: 6 kW, 9: 9 kW
Market E: Europe
Power supply 5: Single phase, 8: Three phase
Model type B: Two-zone model with additional equipment for 2nd heating circuit integrated, C:Compactconguration
WH ‑ A D C 0309 J 3 E 5 C
1 The available capacities di󰀨er according to the series. An overview is given in the model range (→ 1 Model range,
p. 8).
2 J generation requires refrigerant R32, H generation requires refrigerant R410A.