Panasonic AW-UE20WE - Max Digital Zoom; Digital Extender; Tally

59
Max Digital Zoom
[×2, ×3, ×4]
Set the maximum digital zoom magnification.
This is only enabled when [Zoom Mode] is set to [D.Zoom].
Factory settings: ×4
[Note]
Higher digital zoom magnifications will result in coarser
images.
Digital Extender
[Off, ×1.4, ×2.0]
Make settings for the digital extender function.
Off
Turn the digital extender function off.
×1.4
The digital zoom will be fixed at 1.4×.
×2.0
The digital zoom will be fixed at 2.0×.
Factory settings: Off
Tally
[Enable, Disable]
“Enable” or “Disable” is set here for the function which turns on or
turns off the tally lamp using the tally control signal.
Factory settings: Enable
Status Lamp
[Enable, Disable]
[Disable] or [Enable] is set here for the status display lamp.
When you want the status display lamp to stay off while this unit
is in operation, set to [Disable].
Factory settings: Enable
[Note]
Even when set to [Disable], the status display lamp may light up
when this unit is starting up, updating firmware, or trouble is
occurring.