Panasonic BL-C111A - Network Camera - Pan - In Case Where the Main Board Is Replaced and a New MAC Address Label Is Used; In Case Where the RF Board Is Replaced(C131 A Only); Update Firmware

37
BL-C111A/BL-C131A
8.12. In Case Where the Main Board Is Replaced and a New MAC Address
Label Is Used
Rewrite the MAC Address of the RF board
1. Turn on the power after replacing the main board (after a new MAC has been written to the main board).
BL-C131A only : Confirm that the WIRELESS/WIRED switch on the bottom of the camera is set to WIRELESS.
2. Press the Factory Default Reset button after 5 minutes have passed since the power was turned on.
* Do not turn the power off during execution of work.
3. Renew the MAC Address label.
8.13. In Case Where the RF Board Is Replaced(C131A only)
Rewrite the MAC Address of the RF board.
1. Turn on the power after replacing the RF board (after a old MAC has been written to the main board).
Confirm that the WIRELESS/WIRED switch on the bottom of the camera is set to WIRELESS.
2. Press the Factory Default Reset button after 5 minutes have passed since the power was turned on.
* Do not turn the power off during execution of work.
8.14. Update Firmware
8.14.1. Firmware Trouble Shouting
The firmware updating is not completed due to power off, network failure or other causes.