Panasonic Bread Bakery SD-BT55P User Manual

When
the
Start
pad
is
pressed
aE
@eorr--
V7, ‘ee a
wooy
Display
lamp
blinks.
Beeper
sounds.
@orr--
Ne a
This display appears
and operation stops.
DYES
o)
Va
larelcer-licelacmolmlelareliuir-lmerelireli
tela
The oven area is hot (above 105°F).
This may occur during repetitive
use. You must allow the unit to cool
down before reusing.
The bread pan either has not been
placed or has been placed
incorrectly in the unit.
There has been an interruption in
the power supply (power failure,
unplugging of the power cord, or a
malfunctioning of household fuse or
breaker).
There has been a 10-minute or
less power outage. (The power plug
has been inadvertently pulled out or
the breaker has activated.) Alert
indicator appears in the display.
Reason
sf
When the oven area has cooled, all
of the indications will go out.
Press [2] pad, and [==] pad.
Place the pan correctly and then
press pad again.
When
the
pan
is
placed
correctly,
all of the indications will go out.
O
Howtoreset
If the outage lasts longer than 10
minutes, the operation of the unit stops.
Remove the dough and start again
using all new ingredients.
If the interruption in the power
supply is momentary, the operation
will not be affected.
If the power is restored within 10
minutes, the bread maker will operate
again. However, the bread may not
turn out well.
if
the
unit
is
overloaded
and
an
excessive
force
is
applied
to
the
motor,
the
protection
device
will
stop
the
motor.
After
approximately
30
minutes,
the
motor
will
automatically
start
running
again.
It
is
recommended
to
restart
with
fresh
ingredients.
If
the
kneading
blade
is
restricted
by
hard
dough,
take
out
the
dough.
The
unit will restart 30 minutes later.
Check to see if the blade spindle of the bread pan can rotate. If it can rotate,
restart
the
bread
maker
after
30
minutes.
If
it
cannot
rotate,
servicewill
be
required.
— 20 —

Panasonic Bread Bakery SD-BT55P Specifications

General

Brand	Panasonic
Model	Bread Bakery SD-BT55P
Category	Bread Maker
Language	English