Panasonic CF-R1 Series

First-time
Operation
{|)
Enter
the
correct
date,
time
and the
time
zone,
then
select
[Next].
You can also
complete
these settings
at
a
later
time.
®
At the [Networking
Settings], select
[Typical
settings],
then
select
[Next],
(t) At
the
[Workgroup
or Computer
Domain],
select
[No,
this
computer
is not
on
a
network,
or
is
on
a
network
without
a
domain],
then
select
[Next].
The
computer
will
restart.
@
Enter
your
administrator
password and
select
Label on
the
top
surface,
and insert the
shutter-
side
headfirst.
USB Floppy
Disk
Drive
<When
using
a
PC Card-compatible
CD
drive
for
reinstalling>
y
Create
Backup
Disks
for reinstallation
To
create backup
disks,
the
floppy
disk
drive (CF-VFDU03)
and
formatted
2HD
floppy
disks are
needed.
(T) Connect
the
USB
floppy disk
drive
to your computer.
note)-^
The floppy disk drive
must be
the
A
drive.
(2)
Prepare
2HD
floppy disks
and make sure they are
not
in
the
write-protected
state,
and then
set it.
(S)(mm?m
Select
[Start]
-
[Programs]
-
[Panasonic]
-
[Create
Backup
Disk]
and
follow
the
on-screen
instructions.
Select
[start]
-
[All
Programs]
-
[Panasonic]
-
[Create
Backup
Disk]
and follow
the
on-screen
instructions.
(3)
Place
a
label identifying
the
contents on
each
disk.
# Name
of created backup
disk
FIRSTAID
FD
(When the
display for
creating
the
UPDATE
FD
is
shown,
create
the disk by
following
the
on-screen instructions.)
Store
the
floppy
disks
in
a safe place.
They
will
enable
you
to
return
your
com-
'
puter
to
close to
the condition
at
the
time of purchase
should
any
problems
occur,
i
When creating
backup disks, do not run
any other
application
program.
j
When creating backup
disks
and
the
message
[Insufficient
files to
copy]
is
dis-
|
played,
select
[OKJ
and
then
contact
Panasonic
Technical
Support.
j
While
the floppy disk
drive indicator
is
on, do
not remove the
floppy
disk,
power
off
your computer
or
use
the
standby
or
hibernation
function
(Q=
I
"Standby/Hibernation Functions").
|
Be
sure to
create
the backup disk.
|
If
a
backup
disk
is not
created,
it will be
impossible
to return
the
computer
to its
)
original state. In
this case,
contact Panasonic
Technical
Support.
|