starting
Up/Shutting
Down
starting Up
Latch
Power
Switch
()
Power
Indicator
@
Open
the
display
(?)
Slide the latch located
at the
front.
(D
Lift open the display.
,
Do not open the display
wider
than
necessary
(
1
50°
or more).
"1
..J
2
Turn your computer on
Slide
the power switch and hold it for
approximately
one second
until the
power
indicator turns on before releasing it.
(<
0--
After
confirming
that
the power indicator has turned on,
avoid
the
follow-
ing
until
Windows
has completed
loading.
•
Connecting or disconnecting
the
AC adaptor.
•
Touching
the power
switch.
•
Performing any keyboard,
touch pad (or
external mouse)
operations.
•
Closing
the display.
Once
the computer is powered off,
you must
wait
at least ten
seconds
before
powering it on again.
When
the
CPU
temperature rises, the computer may not power on
to pre-
vent the CPU from
overheating.
Should this happen, allow the
computer
to
cool down
then switch
the power
on
again.
If the computer still does not power on, contact Panasonic Technical
Support.
If
security
indicator
g)
is displayed,
Enter
your
password* and press
C
Enter
]
.
(0="
"^Jgjj^i*
"Security Measures")
inrm
The
correct
password
f7=^
Will
Start
Three incorrect attempts
No
password
for about a
minute
f^Hsl
^
Will
Not
Start
*
Supervisor Password
or
User
Password set in the Setup Utility
(not
^PojWrofQ
the
Windows password).
When an
application or
file
that was
previously displayed
appears
on
your
screen,
the
standby
or
hibernation function
(C
"wSSSf*
"Standby/Hibernation
Functions")
has
been set.
Log
on
to
Windows
Wait for
10
seconds
after
confirming that the hard disk drive
access
has been com-
pleted,
input
the user name
and
password,
then
select
[OK], Until
the
correct
user
name
and
password are entered,
the computer
will
not operate.
Wait
for 10
seconds
after
confirming that the hard disk access has been
completed,
select the
user
and
input
the password, then select
^
Until
the correct
password
is
entered,
the
computer
will
not
operate.
14
To Next Page
Loading...
