List
of
Error
Codes
02F5: DMA
Test
Failed
ServerBI0S2
test
error:
Cannoi
write to
extended
DMA (Direct
Memory Access) registers.
02F6:
Software
NMI
Failed
ServerBI0S2
test
error
Cannot
generate
software
NMI (Non-Maskable Interrupt).
02F7: Fall
-
Safe
Timer
NMI Failed
ServerBIOSl
test
error;
Fail-Safe Timer
takes too long.
device
address
Conflict
Address
conflict
for
specified device.
Allocation
Error
for:
device
Run ISA
or
EISA
Configuration
Utility to
resolve
resource conflict for the specified device.
Failing Bits :
nnnn
The hex
number
nnnn
is a map of the
bits
at the RAM
address which failed the memory
test.
Each
1
(one)
in the map
indicates
a
failed
bit.
See
error
230.23
1 or 232 for
offset
address
of
the failure in System,
Extended
or
Shadow memory.
Invalid
System
Configuration Data
Problem
with
NVRAM
(CMOS)
data.
I/O
device
IRQ
conflict
I/O
device
IRQ conflict
error.
Operating
System not
found
Operating
system
cannoi
be located
on either
drive A: or
drive
C:. Enter Setup and see if fixed disk and
drive
A: are
properly
identified.
Parity
Check 1 nnnn
Parity error
found in the
.system bus. BIOS
attempts to
locate the address
and
display
it on
the screen.
If it cannot
locate the
address,
it
displays
????.
Parity
is a
method
for
checking
errors
in binary data. A parity error indicates that some data has been
corrupted.
Parity
Check
2 nnnn
Parity
error found in the I/O
bus. BIOS
attempts
to
locate the address and display it on the screen. If it cannot locate the address, it
displays
??'??.
Press
<F1> to
resume,
<F2> to Setup
Displayed
after any
iBcoverable error
message.
Press
<F1> to start the boot process or <F2> to enter a Setup and change die
settings.
Write
down
and
follow the
information
shown on
the
screen.
To Next Page
Loading...
