22
21
E
N
G
L
I
S
H
CQ-C5403W/C5303W
Balance/Fader
You can adjust the sound level among the right, left, front and
rear speakers.
Default: BAL (balance) CNT (center)
FAD (fader) CNT (center)
Setting range: 15 levels each and CNT (center)
Press [VOLUME] (PUSH SEL).
Press [VOLUME] (PUSH SEL).
Subwoofer LPF (Low Pass Filter)
You can select the upper limit frequency of the sound from subwoofer.
Default: 80 Hz
Setting range: 80 Hz, 120 Hz
Press [VOLUME] (PUSH SEL).
Subwoofer Level
You can change the subwoofer volume level.
Default: 0
Setting range: MUTE (–∞), – 6 dB to + 6 dB (by 2 dB)
Press [VOLUME] (PUSH SEL).
Audio Settings (continued)
Regular mode
SQ Adjustment
You can adjust the characteristics of the currently selected sound type (SQ). (
a
Page 9)
It is also possible to preset up to 5 different adjusted SQs.
Tone/SQ adjustable range: –12 dB to +12 dB (by 2 dB)
SQ Low/Bass : ± 12 dB (at 60 Hz, 80 Hz, 100 Hz, 200 Hz)
SQ Mid : ± 12 dB (at 500 Hz, 1 kHz, 2 kHz, 3 kHz)
SQ High/Treble : ± 12 dB (at 10 kHz, 12 kHz, 15 kHz, 18 kHz)
¡ The bass/treble control level of each frequency is fixed to the frequen-
cy that has been selected for SQ.
FTo return an adjusted SQ to the default setting
q Press [SQ], and select the SQ which is to be returned to the default
setting. (Only for main unit)
w Press and hold [BAND] for more than 2 seconds.
Press [VOLUME] (PUSH SEL).
The SQ adjustment mode can be
established also by pressing
[SQ]
for more than 2 seconds.
[D] (DISP) (Return to the regular mode)
Press [VOLUME]
(PUSH SEL
: select).
(Press
[SEL] on the
remote control unit.)
Turn
[VOLUME]. (Press [VOL }] or
[VOL
{
] on the remote control unit.)
[SQ] (Sound Quality)
[
[
]/[
]
]
[
{
] / [
}
]
[BAND]
Preset Buttons [2] to [6]
To Next Page
Loading...
