Panasonic CQ-DVR592U

71
E
N
G
L
I
S
H
56
CQ-DVR592U
70
Electrical Connections (continued)
CQ-DVR592U
E
N
G
L
I
S
H
55
Connection with CD changer and Extra Amplifier
BATTERY 5 A
External
Amplifier
Upgraded
System
Speakers
Upgraded
System
Speakers
External
Amplifier
Subwoofer
External
Amplifier
CX-DP88U (option)
DIN Cord
L (White)
R (Red)
Ground Lead
Battery Lead
CQ-DVR592U
Changer control cord
CD changer input Cord
FRONT
PRE OUT Cord
(Front)
REAR
PRE OUT Cord
(Rear)
6
Power connector
L (White)
R (Red)
L (White)
R (Red)
(White)
(Red)
Subwoofer Cord
S.W-OUT
CD.C-IN
(Monaural)
Example Combination
≥ CD changer
(CX-DP88U, option)
≥ Stereo power amplifier (option)
≥ Upgraded system speakers (option)
Connecting Side Brake (Parking Brake) Connection Lead
PARKING BRAKE
Parking brake switch
Cords connected to
the vehicle
Parking Brake Cord
Brake Lamp
Battery
Chassis
:
Clamp Connector
(Blue/Yellow Stripe)
Side brake (parking brake)
Foot brake
Element
Cover
Vehicle Cord
Parking Brake Cord
Push the end of the cord
in until it touches this part.
123
Of the 2 cords emerging from the parking brake switch,
connect the player’s parking brake cord to the one that is not
connected to the vehicle’s chassis while the brake is in the
released state.
Connecting : the clamp connector
≥ Attach the clamp connector to the vehicle cord at a suitable position.
≥ Note that if the cord being clamped onto is too thin (0.3 mm
2
or less), the connection may not be
adequate.
1
Push the end of the side brake cord into the hole on the clamp connector.
Place the vehicle cord into the groove in the clamp connector.
2
While making sure that the cords do not slip out of the clamp connector, press the element down with a
pair of pliers.
3
Close the cover until it snaps shut.
Caution:
≥ For safety, be sure to ask your nearest professional installer to do this connection.
The side brake (parking brake) switch position varies with
the car model.
For details on the exact location of the side brake (parking
brake) switch in your car, contact your dealer.