Panasonic CQ-DVR592U

48
Troubleshooting
CQ-DVR592U
E
N
G
L
I
S
H
33
Error Display Messages
❐ DVD/Video CD/CD/MP3
Display
≥ The unit will not operate for some reason.
➡ Eject the disc. If the disc does not eject when you press [<]
(eject), then simply press the reset switch. (➡ page 54)
≥ An attempt was made to play a disc with a region number that
was not “1” or “ALL”.
➡ Eject the disc.
OSD
This disc may
not be played in
your region
Please eject.
Mechanical Error
Please eject.
This type of disc
cannot be played.
Please eject.
Playback Error
Please eject.
This type of disc
cannot be played.
Please eject.
49
E
N
G
L
I
S
H
34
CQ-DVR592U
Display Cause/Step
❐ CD Changer
Troubleshooting Tips
❐ Common
≥ There is a scratch on the disc.
≥ Disc is dirty, or is upside down.
≥ A disc other than a music CD (CD-DA type) is loaded.
➡ Check disc. (The changer automatically switches to the next disc. )
≥ The changer will not operate for some reason.
➡ Press [<] (eject) on the changer. If the changer does not respond,
press the changer’s reset switch. (➡ page 54)
≥ No disc is in the changer (magazine).
➡ Insert discs into the changer (magazine).
Note:
≥ For details, refer to operating instructions for the changer used.
Cause/Step
≥ Disc is dirty, or is upside down.
≥ Disc has scratches.
≥ A disc that has data other than CD-DA or MP3 type is loaded.
➡ Check disc.
≥ An attempt was made to play a PAL disc.
➡ Eject the disc.
≥ When there is no MP3 files in the specified folder during direct
MP3 folder selection.
➡ Select another folder which contains MP3 files.
≥ The player for some reason cannot read the file you are trying to
play. (File recorded in an unsupported file system, compression
scheme, data format, file name extension, damaged data, etc. )
➡ Select a file that the player can read. Confirm the type of data
recorded on the disc. Create a new disc if necessary.
No power.
Car’s engine switch is not on.
➡ Turn your car’s ignition switch to ACC or ON.
Cables are not correctly connected.
➡ Connect cables correctly.
Battery cable is not correctly connected.
➡ Connect the battery cable to the terminal that is always active.
Accessory cable is not correctly connected.
➡ Connect the accessory cable to your car’s ACC source.
Grounding wire is not correctly connected.
➡ Connect the grounding wire to a metal part of the car.
Fuse is burnt out.
➡ Call the store where you purchased the unit, or your nearest
Servicenter (see the attached sheet) and ask for fuse replacement.
Trouble Cause/Step
No sound.
Mute is set to ON.
➡ Set it to OFF.
Cables are not correctly connected.
➡ Connect cables correctly.
Condensation (dew).
➡ Wait for a while before use.