Panasonic CQ-R145U - Installation Guide; Installation Hardware

Installation Guide
, A WARNING
This installation information is designed for experienced installers
and is not intended for non-technical individuals. It does not
contain warnings or cautions of potential dangers involved in
attempting to install this product.
Any attempt to install this product in a motor car by anyone other
than qualified installer could cause damage to the electrical
system and could result in serious personal injury or death.
□ Overview
This product should be installed by a professional.
However, if you plan to install this unit yourself,
your first step is to decide where to install it. The
instructions in these pages will guide you through
the remaining steps: (Please refer to
“WARNING" statement above).
• Identify and label the car wires.
• Connect the car wires to the wires of the power
connector.
• Install the unit in the dash.
• Check the operation of the unit.
If you do encounter problems, please consult your
nearest professional installer.
Caution: This unit will operate with a 12 volt DC
negative ground auto battery system only. Do not
attempt to use it in any other systems. Doing so
could cause serious damage.
Before you begin installation, look for the following
items included in the packing with your unit.
□ Installation Hardware
NO.
Item
Diagram Q’ty
©
Mounting Collar
1
CD
Hex. Nut (5 mm<}>)
1
CD
Rear Support Strap
y-
1
CD
Tapping Screw
(5 mmb x 16 mm)
1
©
Mounting Bolt (5 mmb)
&
1
©
Power Connector
&
1
Dismounting Plate
/
1
• Warranty Card.Fill this out promptly
• Panasonic Servicenter for service
Directory.Keep this for future reference in case the unit needs servicing
• Installation Hardware .Needed for in-dash installation
CQ-R145U
17