Panasonic CQ-R145U - Electrical Connection

Electrical Connection
• This unit can be connected to an optional CD changer (CX-DP801EUC). For details consult your
nearest Panasonic dealers.
• For connection to a CD changer, refer to the operating instructions of the CD Changer (CX-
DP801EUC).
Caution:
• This product is designed to operate of a 12 volt, negative ground battery system.
• To prevent damage to the unit, be sure to follow the connection diagram below.
• Remove the covering of the leads about 5 mm long from their end before connecting.
• Do not insert the power connector into the unit until the wiring is completed.
• Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all
cables and keep cable terminals free from touching any metal parts.
CX-DP801EUC
Ground Lead
To a clean, bare metallic
part of the car chassis
Be sure to connect to a well grounded
metallic part of your car because noises
or troubles may occur.
(White
w/black
stripe)
Battery Lead
To the car battery, continuous
+12VDC
Power Lead (ACC or IGN)
To ACC power, +12V DC
Ground Lead
To a clean, bare metallic part of
the car chassis
Motor Antenna
Relay Control
moves antenna up
and down
Amp Relay Control \
Power Lead \
This lead is for connec- t
tion to Panasonic power j
amplifier. /
Left Speaker Right Speaker
(Front) (Front)
Left Speaker Right Speaker
(Rear) (Rear)
CQ-R145U
23