Panasonic CQ-RX400U

Preparation
cu=
Ec
.....
..... cu
1;;31
.: e
.... 0..
1Set your car's ignition switch
to the ACC or ON position.
c!'\r 2 Press [SRC] (PWR: Power).
~~
2Press [SRC] (PWR: Power).
3 Hold down [VOL] (PUSH SEL: Select) for
2 sec. or more to open the function menu.
B.li'3")I)11 R'I;,*4.:'1I1
The demonstration message appears for initial
use.
1Set your car's ignition switch to the ACC or
~
III,O;O"I,)II
-=
ee
=.-
e(;
......
--
n:scn
==
CDc::.
uE
=cu
~Q
'" fl' ,,,,,,
.-£,. ,- -, L' --L' ...!. L'
III.Bi£f
JeI
•
1i1
4 Press [VOL] (PUSH SEL: Select) to
select DEMO.
STurn [VOL] counterclockwise.
For using the remote control, press [0] (V).
Notes:
• To return to the regular mode, press [DISP].
• Refer to the section on "Function Settings".
• When "NO USB" IR.jjQUlnil) or "NO DISC" is displayed,
the Demonstration cannot be cancelled.
Pull the insulation film out from
the backside of the remote control
gently.
Note: Battery Information:
Battery Type: Panasonic lithium battery (CR2025) (Included
in the remote control)
Battery Life: Approximately 6 months under normal use (at
room temperature)
The 12-hour system is used for the clock.
1 Press [DISP].
Minute entered
Completed
Clock display (Default)
,- ~ ,,~
L-r> ,_,
1- -:: : '- -,
1- -I: :'- -,
Press [DISP] to change the display.
Display off
Clock Display at Power Off
Notes:
• "ADJUST' is displayed before adjusting the clock.
• Hold down [ ~] or [~ ] to change numbers rapidly.
• When "NO DISC" is displayed, the clock cannot be
adjusted.
SAdjust the minute.
[~ ]: sets the minute ahead.
[ ~]: sets the minute back.
6 Press [DISP].
Minute blinks
Hour entered
f.·""
Lr'L'L'
= 1--:':=:1 1
=1,- -'.:=: I I
"" ",,-,
,- -, ...il _, L':..J •
[~]: sets the hour ahead.
[ ~]: sets the hour back.
4 Press [DISP].
(clock display)
2 Hold down [DISP] for more than
2 seconds.
Hour blinks
3Adjust the hour.