Panasonic CQ-RX400U

Troubleshooting (continued)
Display
Possible cause'" Possible solution
-
"CS
Q)
=
c:
.-
-
c:
Q
Co:»
-
-
.~
.c :E
i~
:E
-
L/L, :-1 --1-- ,--' --
LI'--, :-1 --1-- --1--
LI'--, :-1 --1-- '--1--
(After 5 seconds)
t
To next file automatically
U'--, :-1 --1-- '--, --
(After 5 seconds)
t
To next file automatically
Display
A
USB device that exceeds the current capacity that can be supplied was
connected.
For some reason, an over-current was detected.
,. -;. Use a USB memory that has a consumption current of less than 500 mAo
-;. Switch the Source, and select USB (MP3/WMA/AACj mode again.
-;. Check that the USB connector section is not dirty, and that there is no
foreign material.
No operation by some cause.
,.r .... ·. -;. Switch the power or ACC ON/OFF. If this does not solve the problem, unplug
., the power cord and plug it in again. In case the unit is still out of order,
consult your dealer. (-;' Installation Instructions)
The player for some reason cannot read the file you are trying to play. (File
recorded in an unsupported file system, compression scheme, data format. file
f~ name extension, damaged data, etc.)
:7 ... Confirm that the USB extension cable is firmly connected, and reconnect if
not. Select a file that the player can read. Check the type of data stored in
the USB memory. Format the USB memory if necessary.
rl.. A WMAJAAC file can be copyrighted.
,r ... The file protected by copyright is not playable.
Possible cause'" Possible solution
-
Q
..
...
c:
Q
(.)
"CS
Q
a.
",n ,n""
, "L' ..L ,- - L'..L'
The iPod was not recognized correctly .
...
It could take some time for the iPod to be recognized.
... Check the connection .
...
Reset the iPod, then connect it again.
Your iPod has no playable music.
... Download playable music to your iPod .
32
CQ-RX400UlCQ-RX200U