Panasonic CQ-RXBT490W

41
CQ-RXBT490W/CR-LXBT490W
Troubleshooting (continued)
Error Display Messages
Display Possible Solution
Radio
No operation by some cause.
¡ Switch the power or ACC ON/OFF. If this does not solve the problem or
the unit is still out of order, consult your dealer or an authorized Pana-
sonic Service Centre to ask for repairs.
Disc Player (only for CQ-RXBT490W)
(The disc is ejected automatically.)
The disc is dirty or upside down.
¡ Check the disc.
(The disc is ejected automatically.)
The disc has scratches.
¡ Check the disc.
No operation by some cause
¡ If normal operation is not restored, consult your dealer or an authorized
Panasonic Service Centre to ask for repairs.
Cannot read the file
¡ Check the disc.
The WMA file can be copyrighted.
¡ The file protected by copyright is not playable.
USB (MP3/WMA)
A USB device is not connected or the connected device cannot be recognized.
¡ Use a USB memory that is suitable for this unit.
No playable files exist.
An unsupported USB device is connected.
¡ Use a USB memory that is suitable for this unit.
¡ Record files that can be played back on this unit onto the USB memory.
A USB device that exceeds the current capacity that can be supplied is con-
nected. For some reason, an over-current was detected.
¡ Use a USB memory that has a consumption current of less than 1 A.
¡ Switch the Source, and select the USB (MP3/WMA) mode again.
¡ Switch the power off/on, and select the USB (MP3/WMA) mode again.
¡
Check that the USB connector section is not dirty, and that there is no foreign
objects.
No operation by some cause
¡
Switch the power on or set ACC to ON. If this does not solve the problem, un-
plug the power cord and plug it in again (a Installation Instructions). In case
the unit is still out of order, consult your dealer or an authorized Panasonic
Service Centre.