44
14.2. Remote Control Button
14.2.1. SET BUTTON
• To check current remote control transmission code and store the transmission code to EEPROM.
- Press “SET” button for more than 10 seconds.
- Press “TIMER SET” button until a “beep” sound is heard as confirmation of transmission code change.
• To change the air quality sensor sensitivity:
- Press and release with pointer.
- Press the Timer Decrement button to select sensitivity:
1. Low Sensitivity
2. Standard (Default)
3. Hi Sensitivity
- Confirm setting by pressing Timer Set button, a “Beep” sound will be heard. LCD returns to original display after 2 seconds.
- LCD returns to original display if remote control does not operate for 30 seconds.
14.2.2. CLOCK BUTTON
• To change the remote control’s time format.
- Press for more than 5 seconds.
14.2.3. RESET (RC)
• To clear and restore the remote control setting to factory default.
- Press once to clear the memory.
14.2.4. TIMER
• To change indoor unit indicator’s LED intensity.
- Press continuously for 5 seconds.
14.2.5. TIMER
• To change remote control display from Degree Celsius to Degree Fahrenheit.
- Press continuously for 10 seconds.
To Next Page
Loading...
