113
18. Disassembly and Assembly Instructions
WARNING
High Voltage are generated in the electrical parts area by the capacitor. Ensure that the capacitor has discharged sufficiently before proceeding
with repair work. Failure to heed this caution may result in electric shocks.
18.1 Indoor Electronic Controllers, Cross Flow Fan and Indoor Fan Motor
Removal Procedures
18.1.1 To Remove Front Grille
3. Slide the 3 lock knobs on the up side of the
Front Grille to unlock position.
4. Hold both sides of the Front Grille
and remove it by pulling
toward yourself gently.
1. Lift to open the horizontal vane gently.
2. Remove the 3 screws on the Front Grille.
Lock Unlock
Figure 1
18.1.2 To Remove Electronic Controller
5 Hooks
5. Removing 2 pieces of the Control Board Cover
by releasing the 5 hooks.
Figure 2
To Next Page
Loading...
